Manual adjustment of the generator level before executing measurements of a Path Signal

When the APx500 software is handled within each Signal Path of each sequence, a Prompt can be added that allows you to manually adjust the level of the generator before the selected measurements are started within that. To do this, the following instructions must be followed:

(1) In paragraphNavigatorof the respective sequence, mark the 'check'Signal Path Setup, deploySequence Steps, click onAdd Step...and selectPrompt:

2) Add a name that identifies the Prompt, selectEdit Generator Level>Set dBrGand select the channel of the generator you want to adjust:

An image can be added in the tabAppearanceto facilitate generator adjustment recognition when the respective adjustment window appears:

3) When you press START (Sequence), the following window should appear before starting the selected measurements:

• Related Articles

• Insul Online Help Manual

  This version has updated content of the help file built into INSUL and will continue to be updated periodically as changes are made to INSUL in future updates. Online Help Manual

• Calculate the noise level in enclosures when it comes from other enclosures

  This example defines the spectrum of a custom noise source located in a particular enclosure, in order to calculate the levels received in the adjacent enclosures. 1) Draw the plan of the next building on one floor and assign the different ...

• Through which transmission channels can the measurements recorded in the memory of a Nor145 sonometer be downloaded?

  When a measurement with the Nor145 sonometer is performed and recorded, they are stored and encoded on the micro SD card. To download and decode measurements to a computer, NorConnect download and analysis software is needed. Thetransmission ...

• Calculate and Export Partial Level Table by Eighth Bands

  Let us assume the following scenario in the there are 2 point sources, with the sound power spectrum allocated, 3 receivers and a calculation area around all the elements to be included in the calculation of partial levels: Then access the ObjectTree ...

• Generation of different signals simultaneously with APx585

  Since WAV files can be used to transmit them through generator outputs, it is possible to transmit different signals simultaneously by assigning each of the output channels the relevant signal. WAV files can be generated with an audio editor, with ...