Generate Conflict Map with CadnaA

The preparation of a conflict map will be explained by an example:

1. Open the project for which you want to make a conflict map.

2. For more security, save a copy of the project with the optionFile/Save as...

3. Access toFloor options/Us...and configure the different soil uses of the project:

4. Create the relevant soil areas on the map (in this case we will create one):

5. Double-click on the perimeter of the ground area and allocate soil use and, if necessary, allocate the population by Km^2:

6. 6. Configure Mesh parameters and their appearance and calculate it throughMesh/Calculate Mesh:

7. Access toExtras/Calculate Conflict Mapand pressOk ok:

Something like the following image will be displayed:

8. Access toMesh/Appearanceand inParam. Evaluation 1 (Day)click on the folder icon:

9. Select the one that suits best. In this case pal_0_20_step_2 (values between 0 and 20 dB with jumps of 2 dB)

10. Remove selection from the optionLevel Range. The following configuration should remain:

11. PressOk okand something like the following image should be shown:

• Related Articles

• CadnaA Options

  Both CadnaA Light and Professional and CadnaA Basic can be functionally expanded with a number of options. Details about these, accompanied by an explanatory video, will be explained below. BMP option: bitmap and other interfaces Any CadnaA product ...

• Error H0033 - Conflict with antivirus

  One possible cause of the 'Unable to access Sentinel HASP Run-time Environment (H0033)' is that an antivirus does not let the service start. Consequently, the license key will not be detected and CadnaA cannot be executed normally. In order to re-run ...

• Importing orthophotes from a Web Map Service (WMS)

  The following article imports an orthophoto from a WMS into a CadnaA project, where georeferenced level curves were previously imported and configured the respective coordinate system. In this case, the WMS chosen will be that of the National Air ...

• CadnaA/R License Types

  Typically, there are three different types of licenses available in CadnaA/R. Additional options and standards and guidelines must match the type of license of the product to which they are added. All licenses, irrespective of their type, are ...

• Add legend in CadnaA

  To add a legend in CadnaA, you must follow the following steps: 1) Select the symboland draw a rectangle on the canvas. 2) Select editing mode and double-click on the edge of the box drawn in point 1. The following pop-up should appear: 3) In the ...